cars is making a noise when i coast my car is making a noise its between a knocking and i ticking noise i guess is how i can best explain it only happens when i coast not when i push the gas it just ...
...coasting or deccelerating at any speed a clunking/thumping noise is coming from the front right. Doesn't occur when accelerating or breaking, but only when coasting. its not the tie end rods cause it ...
...noise is unchanged whether accelerating, deccelerating, or coasting at 60 mph. Any clues? wheel bearings or diff bearings try coasting wiht the engine shut off down a hill to listen better,or get ...
coasting at lower speeds (30 - 45 MPH for example). Suspect noise to be coming from transmission. Briefly shifting to N will remove the noise. Shifting back to D and continuing to coast, the noise may
...coasting? If it always makes noise when you push in the clutch, it could be the throw out bearing. But if only coasting and not when turning left a little, then a front wheel bearing is more likely. ...
Question about 2003 Protege
...coasting at 50 mph, stops under torque and braking It sounds similar to the noise and old cars transmission that did not have synchronmesh transmission Pull the diff drain plug and check for metal on ...
Question about 2006 Town Car
...mph. Faint rough sound. Goes away when coasting. 2006 Town Car Could be wheel bearing, but no noise when braking or coasting - only when under power. possible rear wheel bearing,rear end or
...deacelerating. only in some gears. only in 4wd? or 2wd? only coasting, only coasting out of gear. see, that takes a skilled mech to do all that and 10x more. to find the SOURCE of said
Question about 2007 Compass 2.4
...issue was on other side.. Maybe you can go up some hill and coast down in neutral to see if the noise is coming from a transmission component. If noise absent while you coast that is a
Question about 2007 Compass 2.4
Kobalt SM2505LW 10 sliding compound miter saw makes grinding noise and slow saw stop During cut saw sounds normal, makes grinding noise after trigger release and the saw blade coasts for minutes. a ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions