nissan scanner). Closed throttle is done by turning the key from OFF to ON position in sequence 10 seconds OFF 2 seconds ON 4 times in a row. IAVL gets done by a scanner. Clean your throttle body flap
throttle my nissan terrrano loses revs it drives fine and starts fine what could be the problem Since this is what should occur when you take your foot off the throttle,Please explain a little more so
Question about 2003 Sentra
...throttle pedal being push I have a nissan sentra s-er 4cyl. 2.5L and i get this problem occasionaly where i press on the gas pedal and it takes 3-5 sec for the engine to respond and then it wont go ...
throttle body cleaner from Nissan and replaced gasket 3. cleaned IACV with throttle body cleaner from Nissan and replaced gasket 4. replaced Mass Air Flow Meter 5. Replaced Spark Plugs I had a similar
Question about 2008 Patrol 4.8
...Nissan Patrol 2008 model. the fault is no acceleration even though accelerator pedal is fully depressed. I bring it to a local garage and the mechanic said the problem is throttle body assembly. But ...
...nissan xtrail petrol, idle too high. A high idle meant there is excess air bypassing the idle control valve. Check for vacuum leaks. Also the throttle body may be sticking open or the throttle cable ...
Question about 2008 Patrol 4.8
Nissan > Sentra The electronic throttle actuator (throttle body) can fail causing a loss of power ... start it studders like it is running on 2 cyl. then switches to 3 cyl. then to 4. but ... Throttle
Question about 2008 Patrol 4.8
...Taolo Lesotho 2003 3300i Nissan Hardbody V6 Question edited for clarity. Clean the Throttle Body and MAF with carburetor cleaner. The Throttle body is soiled with carbon and isn't closing
Question about 2008 Patrol 4.8
...at the stoplights. Sensors recently changed to counter that problem. Clean Throttle Body and MAF. Check for DTC trouble codes. https://www.google.com/search?q=2005+nissan+almera+clean+throttle+body
Question about 2008 Patrol 4.8
...Nissan NP200 8v. Throttle body problem as it's hunting when starting. It also doesn't have the same power as before. What can I do? 2018 model 1600 8v After engine was redone, I have put a new idle ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions