Questions & Answers for: nissan quest tighten belt

...nissan quest have car project!! removed old drive belts. Do not remember where each of them goes over. can you help please! (Diagram of positions) go here for help ...

NISSAN QUEST 1994 WHAT ARE THE STEPS here's 96. should be the same. Be very careful not to overtighten any of the belts or you can break the snout off the crankshaft and ruin you engine. Section 14-02

...belt on 1995 Nissan 240 SXSE (front belt). Can't seem to get power steering unit loose enough to get belt on a then retighten. Thanks There is a tensioner assembly that consists of a long bolt which ...

Nissan Sentra le (4-door). My alternator to crank belt is still loose and tensioner is tight all the way. It's a new belt from car quest parts shop. Need to know how can I tighten it more? go to parts

belt pulley is rattling Which pulley? May want to check the idler pulley locking nut and loosen it and tighten again and see if it is still wobbly. If it is, you may have to replace the pulley.

...belt and tighten or replace as needed. What you have described is your motor mounts need to be replaced and that your serpentine belt needs to be replaced or your tension pulley has gone bad and will ...

...nissan quest how to tighten alternater belt on 2004 nissan quest Best to remove the front passenger side wheel. Then snap out the clips that are holding the plastic cover towards the front. Now it ...

...nissan quest that is over heating and noboby can figure it out .Tthe last mec. put new water pump, thermo,timing belt,drive belt and has checked all water passages for stopage and still get no water ...

nissan quest 2007 whining noise in hood There is a whinng noise in hood when van is turned on and it lasts all the time. Thinking it might be a belt or something but since I am a woman don't ...

...Quest wrong part?; https://www.youtube.com/watch?v=Mwq1h9AZDqY * Replace pulley; https://www.youtube.com/watch?v=G4PS7WHlgi0 * 1997 Maxima manual; ...