Questions & Answers for: nissan quest ecm

...light the overdrive light either blinks or stays on for a short time when my wife starts our 2000 nissan quest. No other known issues. Have the engine and trans ECMs scanned, could have a code

...Nissan Quest ABS, TCS, Brake, SLIP, Service Engine Soon lights are on and speedometer and odometer are not working Retrieve codes from the ECM and report it is possible that the codes are related and ...

where is the ecm located on a 2000 nissan quest? where is the ecm located? Should be behind the glove box.

...nissan quest are good what else could disrupt the power supply to ecm? My husband messed with the electrical wiring of the car trying to fix the fans (they weren't getting up to temperature) ...

...nissan quest IVT I've replaced every sensor on the van did an oil change and drove the van 5k, changed the oil again. The IVT selonoid also changed out and cleared oil passages. Checked wires for ...

Nissan Quest van 3.3 check engine lights on reads code P 1148what sensor would that be code p1148 refers to closed loop control-bank 1-inoperative===causes--wiring--HO2S front--ECM Check the wiring is

Nissan Quest 3.3L my #5 cilynder miss fire, hook a noid light to it it does not light up at all but shows I got power going to it, so can it be the ECM if it is where is located Could be ECM or wiring

...nissan quest gxe minivan if it is like my Quest 1999 model it is behind the glovebox. need to open glovebox and carefully move stop tabs a little to go around frame and will drop glovebox down. the ...

...Nissan Quest I have another Nissan Quest 2003 will the immobilizer off of my 2003 in my ECM off 2003 go on my 2004 and still crank it no needs to be flashed to vehicle go to dealer and have a key cut ...

...Nissan Quest 3.5 Are the timing mark set at 15 degree BTDC? Are the timing mark set at 15 degree BTDC? Probably, but it is all done electronically by the ECM and the Crankshaft Position Sensor. The ...