Question about Power Humidifier: Furnace Humidifier/ Humidifier
...shows the time and an error code of -AC. Help! I have tried flipping the breaker. I had that last night. I turned off the unit for a couple of hours and it came back on and ran and cooled. I have
Question about Power Humidifier: Furnace Humidifier/ Humidifier
...night. The furnace has an error code which is flashing two times - Combustion Ignitor Switch Shut Closed. I have turned off the furnance and thermostat hoping a reboot would solve the problem, but no ...
Question about Trane Furnace Draft Inducer Blower 115 Volt Variable Speed Fasco # A190
furnace does not come on and the LED still flashes code 9'', after initially flashing code 5. The blower does come on and runs continuously (I think it is the blower that circulates air thru the ducts
...furnace go down to 58 at night. It takes all day to get back to 67. Sounds like a dirty flame sensor. Also 9 degrees is a large swing to recover. Most specialist will advise no more than a 5 degree ...
Question about CT3200 5-2 Day Electronic Programmable Thermostat Heater
...night and it goes to 70 degrees at 530AM. When it doesn't start up, in order to get the furnace to work, I have to pull out and reinstall the batteries, run down to the furnace (a Rheem) and turn the ...
Question about CT3200 5-2 Day Electronic Programmable Thermostat Heater
...it frosts up on it. If there is any blockage, it restricts the air inlet. If the furnace ignites, it melts the frost and works fine. It happens mostly at night. Let me know if you find this.
Question about Propane Forced Air Heater w/Electronic Ignition (50,000-80,000 BTU)
...furnace in my house. Last night the meter went bad and we lost half of our power. Now my furnace will not work even though I have 110v to it. I cannot find any lights for a trouble code. If the fuse ...
...furnace GMP075-3 The thermostat was in the off position over night and sometime during the night, the induced blower and blower motor came on. The trouble light on board blinks 5 times. I checked all ...
night, the furnace quit again and gives the same LED code 31. I replaced the pressure switch and it did not help. Any suggestions? Could well be the inducer motor Google carrier 31fault code there are
...furnace quit working last night. The blower would kick on but it won't ignite. the code says reverse polarity. but there was no power outage and no one has messed with the wires. Please help. ...
Usually answered in minutes!
220 Questions
180 Questions
155 Questions
108 Questions
