Question about 2hp Whisperflo Pool Pump In - Ground
Turned on pump it sparked and stopped running breaker didn't trip. 99.9% Sure that motor is bad. Either replace with new(my choice) or have it rebuilt.
Question about 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame
...pool motor pump,around 15 years old. Just the other day it started making a loud whining noise. Is there a quick fix for this? if its whining but still spinning, the bearings are done. If it just ...
Question about 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame
...pentair whisperflo wfds-28 2hp part 7 177456-03 that works fine on low speed but only humms loudly when trying to go on high speed. Is there a capacitor or something that has gone bad? Thank you, JOE ...
Question about 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame
...2hp pump is making a loud whining sound when running, is this a bad bearing? pump was new in july 2012. ran extremly quiet and strong. I turned it on one day and it just hummed so I turned it off and ...
Question about 2hp 230v Ur Mh Challenger High Flow Pumps
proline 2hp pump not getting water pressure make sure top seal ok if ok check intake union make sure tight check impeller for debris
Question about 1.0 Hp Whisperflo Pump
...new motor for that one.The motor is making a lagging noise like it This pump was put in last May by my pool company under warranty. The pump runs year round with a Pentair Controller on average of 18 ...
Question about 2 hp WhisperFlo InGround Pool Pump WFE28 ()
pentairPen pentair 2Hp whisperflo pump comes on then shuts off motor overheating replace motor or pump
Question about 2hp Pool Pump Motor Ao Smith Electric Motor for Pool & Spa Pumps Bn40
new pentair 1 hp pool pump replumbed and did the electrical connection. motor get real hot and shut off. i used the correct 12 ga wires and wire it for 115v. do you think i got a bad pump. it did have
pentair challenger 2HP pump start capacitor check the bump on back of motor remove cover take picture of wires then get new one from electrical supply store
Question about 2.0 Hp Whisperflo Pump
My pump is running, but today it developed a loud high pitched whine. Can this be repaired or replaced; Bearings, impeller? Bearing problem. Replace both front and back bearings along with shaft seal.
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions