...new ignitor wire did not have this spud in the end of the wire. It had a female electrical connector on the end like the old one, but no spud. I was able to remove the spud from the old ignitor wire ...
Question about 40494 / 40495 / 40499 Electric Single Oven
...new ignitor Kenmore gas oven with new ignitor won't fire. 120 volts to ignitor & still won't fire. 120 volts to one side of safety valve, 0 coming out. Stovetop works fine. Any ideas? Thanks, Ted if ...
Question about 40494 / 40495 / 40499 Electric Single Oven
new ignitor My gas dryer stopped heating so we took the burner assembly out, had continuity tested and everything but the ignitor checked out. Believe the ignitor burned up when a charcoaled mouse was
Question about 40494 / 40495 / 40499 Electric Single Oven
a new ignitor and it works fine././/now you have a defective gas valve....new ignitor but no gas....The gas valve is wired through the ignitor and makes it difficult to diagnose...especially on here :
...new ignitor will not light up.any ideas what might be the problem . The new ignitor came with diffrent clips I had to chose the one that fit my furnace,does it mather witch way the wires go into the ...
...not work, ignitor does not light and replaced with new flat ignitor. broiler flat ignitor works fine, same with range top, all other works. I have power to ignitor. hi, Where can i buy the grate
...inside the clamp and it will tell you how many amps are coming out of the ignitor.buy a new ignitor and you should be fine.it calls for ignitor part number 31940001 and it's around 50
Question about Minimax Nt Heater Igniter (471602)(472604) ()
...new ignitor P/N 472604. Worked with P/N 471602 Ignitor, but not after replacing. The ignition system was then replaced but the new ignitor still does not light. We smell gas and can light the burners ...
...new ignitor too and and have power from both. Is it possible that I purchased a bad ignitor? Are there other tests I should be doing to diagnose this problem? Any assistance would be apprecaited. The ...
Question about 91112 / 91114 / 91117 Electric Kitchen Range
...ignitor. I installed new burner tubes and ignitors. Problem is that new ignitors do not heat up at all. The broiler ignitor works fine. Any ideas on what might keep the oven burner ignitors from ...
Usually answered in minutes!
383 Questions
170 Questions
215 Questions
107 Questions
112 Questions