Questions & Answers for: neon check bent valves

NEON HADA BOLT FALL INTO INTAKE ABOUT 2 MONTHS AGO AND JUST LEFT IT IN THINKING IT WAS TOO HEAVY TO MAKE IT TO THE VALVES NOW IKT STARTED TO KNOCK SO I TOOK INTAKE OFF AND GOT THE BOLT OUT BUT IT ...

...neon. however ive been unable to get it started. ive lined up the mark on the cam puley to the mark on the crank puley and have tried moving it a tooth in and out and still nothing. Do you have any ...

...neon 2002 and it makes a clacking or ticking noise but wont start You probably have a bad or failing battery. Will it jump start and continue to run OK? If the timing belt is broken, the car is ...

...neon wants to cut off and the check engine light and oil pressure light comes on when I stop! When I take off it goes out why? This only happens when I stop. Otherwise it runs good! Its like the idle ...

...Neon DOHC. I am told that this is an interference motor, hence valves could be damaged for starters. NOTE: The belt broke when I just came off of a light and was only going about 10 mph. I am now ...

...NEON) I have installed the larger DOHC engine in this car about a year ago. Recently, the timing belt broke. It IS an intermittent engine. I have the valve cover off and it appears that 2 valves are ...

...neon timimg belt broke did it bend the valves maybe between two to four are bent . remove valve cover, timing belt upper to turn cam, pull # 1 plug rotate crank untill piston is at mid point all ...

...neon ,just quit running,getting gas,air,spark checked fuel relay,but eiher way getting gas Check for compression. Depending on odometer reading, it is possible that the timing belt may be broken or ...

...neon just shut down not hot no check engine light came on no nothing like i ran out of gas but it didnt gas pump working and its getn fuel the timing belt broke i replaced it and still it will not ...

NEON DIED I JUST REPLACED THE SPARK PLUGS AND THEY LOOK ,IKE THE OLD WAS BURT LOOK TO THEM I suggest you check the timing belt/valve timing and replace if necessary ad then perform a compression test.