needle is in the highest position before you try putting the bobbin holder in. The bobbin holder has a metal 'finger' which fits into a 'slot' in the housing and it only goes in if you have the needle
needle broke and a piece is under the bobbin holder. How can I get under the bobbin holder? I was able to gain entrance into the area by taking out 1 screw (star head), slightly pulling on the plastic
Question about XL-5130 Mechanical Sewing Machine
...needle holder came off rod.n needle holder assembly fell off rod.need to know how to put back on rod. The needle holder has a screw right above the screw that holds the needle in place. It really ...
Needle holder fell off of machine I went to replace the needle on the machine. When I turned the screw & pulled the needle out, the entire needle holder part came off. I can't see how it stayed on
Question about XL-5340 Mechanical Sewing Machine
...NEEDLE HOLDER FELL OUT. If, you can't just screw it back on, I would take it in for service. You may be able to take it to your dealer and ask how it goes back on but they may charge you. Without ...
...too try sewingpartsonline.com whole part that has needle in fell off, needle is still in situ but its not obvious how to get the whole holder to stay on pole, it goes on and falls right off
Question about XL-5340 Mechanical Sewing Machine
...now I can't replace the needle the needle seems to not go into hole and wont tighten it's possible that the needle clamp holder needs to be replaceda sewing machine shop can tell you for ...
...needle holder from falling off. The screw on the back should be very loose. Place the holder on the arm (moves when you rotate the wheel by hand) with the screw towards the back and the hand screw on ...
needle holder correctly and tightened into the needle holder correctly.. if the needle was in the needle holder correctly and it's still hitting the bobbin carrage then the machine needs to be checked
Question about XL-6562 Mechanical Sewing Machine
...needle holder is usually held in the shaft that moves up and down with a set screw. This can be either a phillips, flat or allen type screw. If the set screw becomes loose the part will fall off. ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions