needle hits the throat plate The needle misses the hold where it should go through and hits metal one the throat plate. I fixed the sewing problem, it was a belt. if a new needle still wont align with
Question about CS6000i Computerized Sewing Machine
...needle that hits a pin can break. Always remove the pins from your fabric before they reach your needle. * Don?t pull your fabric as you sew You could be bending your needle back, causing it to hit ...
...needle that hits a pin can break. Always remove the pins from your fabric before they reach your needle. * Don?t pull your fabric as you sew. You could be bending your needle back, causing it to hit ...
...needle that hits a pin can break. Always remove the pins from your fabric before they reach your needle. * Don?t pull your fabric as you sew You could be bending your needle back, causing it to hit ...
...needle hits the base plate about 1mm on the far side of the hole. You may have the stitch setting on the left/right(depends which side it hits) setting, or the needle is un-noticeably bent. Depending ...
...needle plate. If that doesn't work,change your needle plate. If you've been using a straight stitch needle plate (a plate with a small hole, often used for sewing fine, delicate fabrics), switch to a ...
Question about 132QRFB Mechanical Sewing Machine
...plate. first change the needle--flat side to the back of the machine, make sure the needle is inserted all the way up into the needle holdermake sure it's the correct needle for the machineif the ...
Question about 132QRFB Mechanical Sewing Machine
Needle hits the plate and bends. What would cause this? The machine seemed to work fine before, but now the needle hits the plate when sewing. I'm assuming something is causing the needle to ...
Question about 132QRFB Mechanical Sewing Machine
...needle is straight; however, it hits the edge of the bobbin holder on my Kenmore Sewing machine. This is my first time trying to use twin needle. How can I adjust this? The needle should not hit the ...
hits the plate, how do i fix it ? check that the needle is fitted correctly check for bent needle check for correct needle First, check what plate is inserted and what stitch is in use. There are some
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions