...needle that hits a pin can break. Always remove the pins from your fabric before they reach your needle. * Don?t pull your fabric as you sew You could be bending your needle back, causing it to hit ...
needle hits bobbin case... Needle hits bobbin case If the needle hits the bobbin case the are only 2 things that could be wrong. Lets hope its the easy one, there are more than one length of needles, ...
My Singer 6160's needle is hitting the bobbin plate. Can't figure needle setting. The needle keeps hitting the bobbin plate. first change the needle--flat side to the back of the machine, ...
Question about CG500 Mechanical Sewing Machine
Needle hits the needle plate. Needle was replaced. Verified needle in correctly. Tried hand wheel - still hits. Machine has yet to be used!! Needle hits the needle plate. Needle was replaced. Verified
Question about CG500 Mechanical Sewing Machine
...needle is straight; however, it hits the edge of the bobbin holder on my Kenmore Sewing machine. This is my first time trying to use twin needle. How can I adjust this? The needle should not hit the ...
...Needle hits bottom of bobbin area and needle breaks Is the needle all the way up? Are you sure it's actually hitting the bobbin? It MAY--and quite possibly IS--inserted too low in the needle clamp. ...
Question about Confidence 7463 Computerized Sewing Machine
...needle in the down position it hits the ruffler foot You may need to move the needle position left or right. Try a different stitch length. If the ruffler foot is installed correctly and needle is in ...
Question about Confidence 7463 Computerized Sewing Machine
...needle, it hits the bottom a d would break again! have a service done and check the needle and hook timing it is a reason that needles hit and break Consult your owner's manual for instructions on ...
Question about 8770 Curvy 225-stitch Computerized Sewing Machine
Needle hits plate under bobbin case wrong needle then it's too long If the needle is hitting, install a brand new needle because the old one may be bent or damaged. If it continues to hit with a new ...
Question about 8770 Curvy 225-stitch Computerized Sewing Machine
The needle is hitting the plate all of a sudden? If it hit all of a sudden it most likely was your needle got bent. Replace needle and don't pull the material. Let the foot do the work. The needle is ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions