Questions & Answers for: need change wires sta rite

...pump as a 115, and it popped the breaker. I put the black wire on 1 and the white on 2. Should I have wired it as 230? Should I switch the black and white wires, even though the directions seemed to ...

my pond pump is making a strange and louder than mormal noise, but it is still working bearings bad replace motor

...MOTOR HOW TO CHANGE FROM HI - LO VOLTS . THATS ALL YA GOT TO DO ..THE WIRES HOOK UP NORMALY If you have changed to the internal setting for 115 volt, just connect your wires to the line in ...

...sta rite 1 hp 115/230 motor i cant find where the white wire goes do you have a diagram I assume you mean the white wire under the rear motor cover? If so Sta-Rite puts a wiring diagram inside this ...

pump is brand new and runs for a time then shuts off then after atime turns back on. pump feels hot to touch. pump is hard wired to a timer. pump is wired with 12 gauge wiring. make sure if wired 120 ...

should i run my 1 1/2 sta-rite at 230 or 1152 IF THE WIRING IS OVER A 100 FEET YOU SHOULD USE 230.

...change 115/230 starite pool pump 1.5 hp the pump came wired 230 but pool was not ready then pool got ready about a month but the deck was not ready so the pump was wired 115 temporialy 6 mths runs ...

...change a hayward pump from 115 volts to 230 volts, I need a wiring diagram The wiring diagram on the motor is un readable. I am changing the 115 volt motor to a 230 volt motor. Is there a wiring ...

Sta-Rite irrigation well pump MSE-6M82 turns on but no water. How do I prime the pump? 1 HP 115/230 V Motor C48L2FC4VHC3 there's a small plug on the side of the pump. fill a gallon of water, plug back

...models: Sta-Rite Max-E-Glas, Max-E-Glas II, Dura-Glas, Dura-Glas II, Dyna-Glas, Dyna-Max Pentair Whisperflow, Pinnacle and Anthony AR2 Series. You should also show what voltage you are connected