Questions & Answers for: murray riding mower blades engage

...Murray riding mower, when engaging blades the engine shuts down. The blades are clear, belt is adjusted correctly, I read seat and engagement switches with meter and they are functioning properly. I ...

My murray riding mower chokes out when engaging drive train or when engaging blades... any suggestions? i had a murray years ago and i had to replace some bearings but i don't recall were.

...Murray ride on mower, small hi, I have an older Murray ride on mower, small one 1984 8 Hp (engine in the rear )seems good order but when I engage the cutting deck to mow the engine dies, grateful for ...

...it me or the mower and if so what is wrong and what do I do? is one of the blades bent?is one of the bearing s seized or binding murray riding lawn mower stall when cutting yard 16.5 hp 42i wide

Safety switch located where is the safety switch located? Will this keep the blades from engaging? Micro switches will just stop the engine if the blades are engaged and the operator leaves the seat, ...

...murray mower deck TROUBLESHOOTINGmanual 2004 Murray model 465306x8A 46" lawn tractor w/21HP Briggs & Stratton engine runs fine UNTIL the mower deck is engaged; then the engine immediately shuts down. ...

murray-riding-mower-tractor-parts/model-46256X9A/0739/1509200/WL000420/00006.html - Basically when you engage the belt drive, the pulley identified as #25 rotates into position to take up the slack in

Murray riding lawn mower, whenever I engage the mower the engine dies, otherwise it runs .... My dr feild brush mower ... cuts off when I engage theblades. ... My Huskee only shut off once I put it in

...Murray riding lawn mower engine runs well when I engage the blades it spits and sputters and starts backfiring what could be the problem Sounds like bad fuel....runs fine when not under stress but ...

...mower .A murray MT100! build date 2005 twin blade 107 cut belt has come dislodged ,in urgent need for a belt diagram please I have tried to re fit the belt and even when engage the belt drive I seam ...