Questions & Answers for: mtx thunder 4 channel bridged

...MTX Sledgehammer box with 3 - 10" Thunder 4500 subwoofers. The box is wired up to one channel at 4 ohms. It has an RMS rating of 635 watts. I purchased this amp because the bridged power is 800 X 1 @ ...

...MTX T4512-04 subwoofer. It is a SVC, 4 ohm sub capable of handling 225 RMS watts. I need help finding an amp to work for this setup. I think I will go with a two channel because of cost. Any help is ...

...4 channel amp item no# 32440 can you help me Here are the specifications i could find on this model. Amplifier Type: Mono RMS Power @ 4 Ohms: 750W x 1 @ 4 ohms THD at 4-Ohm RMS Power: <2% Bridged RMS ...

...MTX Thunder Elite 801D at about $600. It'll give you 800 watts which will still make those L7's louder than most people can stand. And if you want even cheaper, but still good, consider the Kicker ...

...bridged into 2 ohms dynamic power If your amp can drive a 2 ohm load then you need to configure your speakers for such a load 1 DVC 12 inch sub with 4 ohm coils wired in parallel would give you two ...

...channel here are the specs for the amp stereo or bridged mono output Tri-way capable (Tri-Way crossover required) 100 watts x 2 at 2 ohms 200 watts x 1 in bridged mode requires 10-gauge power and ...

...MTX THUNDER IN THEY ARE IN A 2OHMS BOX BUT WHEN I HOOK UP JUST ONE CHANNEL IT SOUNDS GOOD I TRY BRIDGING IT BUT NO SOUNDS THE AMP DES NOT CLIPS OR ANYTHING JUST THE SOUND IS HORRIBLE DOES ANYONE HAS ...

...MTX Thunder 404 400 watts into one channel The mtx thunder is a 4 channel amp. 4 channels can't be bridged to 1 speaker. You can only use one side of that amp to bridge your speaker. Unfortunately ...