Questions & Answers for: mr2 engine turn

Question about 1992 MR2

2 Answers

...you sure it is not the entire key mount that is turning as well? had a friends who had just popped out of place. just finished fixing one mr2 1992 with same symptom. engine to body ground came

Ad

...my 1991 MR2's AC compressor. This happens if the engine RPM is increasing or decreasing. I would replace the compressor, if it seizes up, the belt will keep turning over the pully and burn then ...

Ad

MR2 was working great until the water pump ceased up causing the timing belt to break, I had to have the engine changed due to the damage caused? anyway the mechanic got me a motor from Japan he said,

...MR2 and recently the engine shuts off on its own WHILE I am driving after about 10 minutes or so on the road and requires ~15 mins parked before the engine will turn on again (with a short time limit ...

mr2 mk2 rev 1 1990 3sfe engine oil leaking form sump i did remove the sump and reseal it was ok . when runnig engine but started to leak when i turned off engine the temp stays below halfway the the ...

...MR2 MK1 Transmission The ring gear is mounted to the flywheel for your starter teeth to engage and turn the engine. Most all cars have this ring gear. If you are having problems starting it may be ...

can your coil cause your car not to crank? the engine will crank ( turns over ) but will not run because there is no spark. if the engine is not turning over or crank then the starting system is bad ...

Question about 1992 MR2

1 Answer

...mr2, had not been moved since Friday and has been out in the cold. Tonight I tried to start it and the egnition turns over but the engine does not start. All of the electrics etc are working fine but ...

...MR2 Spyder. In Maryland, you have to do emissions. The first time it failed because I needed to replace an 02 sensor. When it went back, it failed because my check engine light bulb was out. Is there ...

Question about 1986 MR2

1 Answer

...mr2 86 doesn't crank Make sure you have a good battery/connections. Make sure you have power down to the starter on the B+ terminal if not replace faulty wire or clean/dirty connectionson ensure ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...