mower and smoke started pouring out of it. I opened it up and it looks like the electric brake melted (tough to tell exaclty what it was, just a big coil of wires and melted plastic) Where can I buy a
Question about 19" Electric Lawnhog Mulching Mower with Rear Bag
...mower blade(its a rear engine rider) it did this 3 times, after the third time the spark plug wire started to smoke then it melted Carb needs cleaned as it can't handle the load of the engine and the ...
Question about Lawn Tractor 48" Deck, 23 Hp, Model# Yth2348
...mower deck will shut off when the switch melts and the push/pull button will pull out of the housing. wires do not appear to be getting hot and clutch will pull in everytime until switch gets hot. I ...
trying to start and wire harness burned at starting wires under seat became hot and melted all rubber off. look for a shorted wire
...mower stopped working suddenly after the key became hot enough to melt. After it cooled I tried to start it but it was instantly hot & let out a puff of smoke. It won't work at all now. I ...
Question about Zero Turn Mower Z5426
...mower wires melting bought used 600.00 dollars got it home put it on battery charger because man said battery was dead. Looked under hood and wires were melted. Changes out those wires for new ones ...
...mower wont start I changed the solenoid and still wont start it just makes a clicking sound when I turn the key also the cables battery cables get hot any suggestions Check to make sure the back of ...
...mower continued to run...had to pull the fuse to stop it. Is it possible that the solenoid wires were reversed. Battery was wired correctly. Also noticed the terminal that the red wire was connected ...
Question about 42 In Deck 19 Hp Kohler Courage Twin Cam Zero Turn Mower
...mower and the blades stop turning while mowing. The PTO switch knob melted. I replaced the PTO switch and the blades turned for 5 min. and then the PTO switch melted again. Elertric blade drive ...
Question about Tractor Starter 285 345 2243 Lx178 188
...a short in the circuit, review any connections made in particular the polarity, the way current passes through a circuit often determines the resistance (low resistance= high current=melted
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions