Question about 1996 Continental
...motor mounting screws and motors. If necessary, remove Constant Control Relay Module (CCRM). Reverse procedure to install. Torque CCRM screws to 40-56 in lb, and shroud retaining bolts to 24-48 ft
...is an automatic transmission as well. Thanks for any help that can be offered. Did you disconnect the torque converter bolts also? If so, get a jack, support the tranny and pull motor from the
When accelerating the car feels like it on a wash board road, I think torque converter any Ideas? It a 95 T/C check your motor mounts
...motor mounts are secure. Nobody at a shop can find the problem. New fuel filter, egr valve, injector cleaning, new plugs, transmission serviced and checked, nothing shows up on computer diagnostic ...
...MOTOR 5.0L Engine Disconnect the negative, then the positive battery cable. Drain the crankcase and the cooling system into suitable containers. Drain and recycle the engine coolant. Properly relieve ...
...motor.. lol, Is it hard to replace? no lay it to rest. It can be complicated: 5.0L Engine Disconnect the negative, then the positive battery cable. Drain the crankcase and the cooling system into ...
...torque converter...If it's loose, there will be movement in that area....If the converter bolts are found to be loose, the flywheel will have to be replaced because the bolt holes will be ...
Question about 2003 Mountaineer
...Motor mount (especially opposite side) , transmission mount. Have you tried brake torque to see how much engine shifts? Once your up to higher speeds, less torque required to push that Big thing down ...
...motor mounts can be bad, the Trans can be worn. The Torque Converter lock-up can be worn. Brake calipers could be sticking.Sometimes the Torque converter engagements are electronically controlled and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions