...motor with four leads, and, of course, the green ground lead. The leads are red, (low speed) orange, (line) and two black leads. One black lead (high speed) goes to "line". My question is, ...
...lead goes to which lug.Need help please. An AC motor has 2 leads and does not have a polarity. Just conntct the two terminls and reassemble the unit. If nothing else is wrong, it will work fine
Question about 1400 Little Green Pro Canister Steam Vacuum
pump motor on Bissell 1400 Little Green Machine need to know where the wires go on the pump motor When I reassembled mine, there was 3 wires connecting to the motor, Green, black and red. The Green ...
...motor replacing the leads from the old one with the leads from the new one. But if the new motor has different colored leads, usually the brown leads are attached to the capacitor (it doesn't matter ...
leads (wires) with tip and it will light up when u hit a hot circuit. if u get a hot lead then u will have to pull door panel and test motor.if motor has no power than its the switch, if motor has hot
Question about Leeson Reversible Electric Motor 3/4 HP
...leads and is a 240/480 volt motor the 1and 7 go to line 1. the 2 and 8 leads go to line 2 and the 3 and 9 leads go to line 3. the 4 5 and 6 leads are hooked together with a wire nut. To reverse ...
Question about 2003 Altima
the battery.. One on negative one on positive. touch the leads from the motor with the leads from the battery. reversing the positive and negative leads, change the direction the motor turn
Question about 100 Amp GE Load Center
Motor leads 4, 5 & 6 connected together and wirenut. Motor leads 1 & 7 to L1 and wirenut.; Motor leads 2 & 8 to L2 and and wirenut and lastly, Motor leads 3 & 9 to L3 and wirenut
Question about Crosswalk 500 Treadmill
...Motor leads disconnected from the MCB, you can connect the machine to the power, Press Start, and if this trips your Fuse Box you know its definitely the MCB. Only carry out these tests if you are ...
motor leads and identify the run winding leads (usually labeled T1 and T2) and the start winding leads (usually labeled T3 and T4). Swap the positions of the T5 and T8 leads. Swap the positions of the
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions