...motor was knocking pretty bad, and it got louder as i accelerated. i was driving home tonight and i could hear the knocking. all of the sudden i heard what sounded like a pop and the motor shut down, ...
...shut it off the motor shakes from side to side quit a bit. Motor shuts off fine but rocks a lot. Just wanted to know if this was normal for a 4.2 liter v6. Mechanic said motor mounts looked fine and ...
...in the way of the door anything fall down the deforster vent lately. About the only thing in that area that could be knocking is your blower motor. Check to see if the squirrel cage on it is
shut down immediately after. I tried starting it again but it wouldn't start anymore. Mechanic checked my car with the following results: - compression on the 3 front spark plugs are good; compression
...shut off it sets a Po325 engine knock sensor error and one pending just after clearing the codes before the engine was started. Does this consistantly every time. I would suggest that you check your ...
...knocking sound would be failure of one or more of your engine bearings due to oil starvation.You could try refilling it with oil and cranking it to see if it starts, then measure the oil pressure and ...
clutch knocks and shuts off when put in gear Motor will start but knocks in clutch and shuts off when put in gear. Your clutch is either out of adjustment or the clutch is fried.
Question about 2004 EN 500 Vulcan Classic
...motor. So try moving the controls to recirc before you shut it off and if the noise does not occur the recirc motor will need to be replaced. If you already have it on recirc try moving to fresh air ...
Question about 2004 EN 500 Vulcan Classic
...motor mount. With the limited information you provided, I can only give a possible solution. The knock you hear might be the valves slamming shut (pinging) due the use of 87 octane gas. If it is a ...
Question about 2004 EN 500 Vulcan Classic
I restarted it knocked and shut off again, is this a safety feature or a blown motor?? it is a safety feature but restarting it may have done more damage , knocking will be the rods and main bearings
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
