Questions & Answers for: moen posi temp cold

...Moen Posi-Temp Valve is a pressure balanced valve and when not used for long periods of time they can stick causing only cold or hot water to pass through the valve. A New Posi-temp cartridges can be ...

moen posi-temp for shower pressure I have a moen posi-temp faucet in my shower and my hot water heater is an instant hot(gas) There is not enough hot water pressure coming out of the posi-temp to ...

posi temp valve has hot and cold water reversed. When the water is turned on, hot water comes out first. As the handle is turned further counter clockwise, it becomes colder until only cold as handle ...

...posi temp, but i don't know how. help turn the water off to the shower,sometimes you must shut down the whole house at the main ,near the water meter,then take the handle off slide the clip in front ...

...Moen single handle posi-temp valve and the waters hot instead of cold when you turn it on, hot and cold are reversed...how do you change it around? You have to remove cartridge and rotate 180 degrees ...

...posi-temp single control installation(moen L82691), and with only the cold water supply on, there is very low water volume when the cold is turned full on. Hot water supply is not available until I ...

Moen Posi-Temp tub valve runs only very cold or very hot. whats wrong? Your Moen valve is equiped with an anti-scald device (as part of the valve cartridge) which prevents someone from getting scalded

...Moen posi-temp cartridge. Hot & cold water is correct but water will not shut of*** the way. I just had the same experience, except I used a non-Moen cartridge. (It was from Ace Hardware, and Ace ...

...moen posi-temp shower valve and it says "up" on 1 side. when it is installed this way the hot is on the wrong side. the hot is hooked to the left side but the handle points to the cold ...

...Moen valve is set all the way to Hot or set all the way to cold. Also, when this was initially installed 8 years ago, we seem to have even less water pressure. Is this because of the posi-temp ...