Questions & Answers for: mode 1 treadmill

...Mode, Section 2. Verify DC voltage at connector P6 pins 1 and 2. Verify that LED 4 on the Motor Controller flashes as the motor moves. Let me know if you need any more help. Fitness Fix-It i have ...

1 ENTER ENGINEERING MODE • With the SAFETY KEY in place, hold the “ELEVATION UP” and “SPEED DOWN” buttons for 5 seconds. “DGA3” will appear in the profile window and “EHG1” will appear in the function

...1 to switch from the Demo Mode:Press and hold the STOP button while inserting the safety key to enter the userinformation mode.Press and hold the STOP button while inserting the safety key to enter ...

...1) Press the MODE. Stop at DISTANCE. The computer will change mode in the following order: SCAN > TIME > SPEED > DISTANCE > CALORIE > PULSE 2) Then press RESET to reset the DISTANCE. ...

1. Determine mileage. A. While in Dormant Mode enter Test Mode by pressing and holding the Heart Rate and Level keys simultaneously for five seconds. B. Press the Dist key. DIST appears on the display

...1 treadmill I need to see if anyone knows where I can find a motor Shroud for the PreCor 9.1 1991 model. Part #31747-103 go www. precor.com or www. fitnessrepairparts.com or www. ...

...Mode: 1.the STOP button while inserting the safety key tPress and hold o enter the user information mode. 2.Look in the Calories window. When Demo Mode is active, the letter 'd' will appear. 3.Press ...

...1 treadmill and I turn the switch on and top display lights do not light up. Is this a switch problem or other? Step 1:1) test the fuse see the block diagram 2) replace the old batteries by new ones ...

...MODE. 1. Turn off the treadmill. 2. Press FAST and START simultaneously and release both buttons once the display lights up. 3. Hold the fast button until the display reads 99. Short in capacitor, ...

...1 on 425 hr clubtrack plus treadmill not stair climber Perform the following steps to configure the treadmill. Enter the service mode For the HR ClubTrack Plus, enter the configuration by using ...