Questions & Answers for: mixer blades hitting

Stuck blade I can't get the blade off. I've been steaming the spring but still nothing. Any other suggestions? the spring is stuck in the release pin. usually wrapping it in a hot steamy towel for a ...

hobart slicer knife (blade) removal, how to Use a hammer and punch.Hit the nut in the middle of the knife to the left,unscrew then remove

how to change blade on model 2912 Remove the knife cover,then get a punch and hammer and hit the center screw on the knife counter clockwise---reverse to install.

I am trying to fix the dial on my hobart slicer any ideas The hobart model 1712 slicer, dial is stuck about 1/2 inch down from the blade. doesn't go up or down, bought it used and everything else is ...

blade is hitting the bowl and the screw will not turn anymore I tried to adjust the screw so the blade would not hit the bowl, but it will not turn to the left any further. Does ant one know what is ...

...from your description that the the head connecting to the base shaft needs tightening. Put the mixer on it's side UNPLUGGED. Look up inside the base and you'll see a small set screw. With a flat ...

hitting the bottom of the bowl. If it is a lift bowl mixer there is an adjusting screw on the frame of the stand behind the bowl holder mechanism. It rurns a cam which adjusts the height of the mixer.

this mixer is about 23 years old. When I try to mix a thick dough, it seems to stop and not have the power to continue mixing even though it's in the "on" position. It also seems that ...

...MIXER IS CLUNKING I am having the same problem. The head wiggles when beating and the blade is getting worn on the bottom, protective cover is getting worn off by hitting bottom of bowl. I have to ...

...mixer and then turn it on it makes a loud clicking noise. We thought it was the mixing attachment hitting the bottom or the bowl but it makes the same noise with or without the mixing blade attached. ...