Questions & Answers for: mitsubishi power generator mge 4000

starts and then shuts off when I start the generator it runs for about 15 seconds and then stops. There is fuel flow at the on off valve screen, the carb has been cleaned, the fuel cap is not stopped ...

I need a wiring diagram for a hitachi starter generator on a yamaha golf cart, the terminals are labled A1, A2, F1 with internal regulator. Thanks , Roy here you go http://www.electricgeneratorsdirect

When I have it on it stays on high idle speed. When I push the auto idle it will not change the speed to normal. It idles at high speed all time. If you have anything plugged into the generator, ...

i have a situation where it worked perfect (output) , went to use it other day....only puts out half output. when i go to plug a drill, it revs up, but wont turn the drill or anything else help.......

Mitsubishi MGE 6700 generator. Starts and runs fine, but no longer putting out power. What would it cost to repair this issue? These generators have a GFI outlet on them, and they do fail. I would ...

...mitsubishi mge 4000 This type of generator has an oil-level sensor to prevent operation when it is too low.  Check to see that the oil is filled to the right mark on the dipstick, and be sure it ...

...power supply seems to be correct (this is without voltage specks) voltage starts about 8.86 key to on postion about 6.00 v. key to start 3.85 This type of generator has an oil-level sensor to prevent ...

i have gaz in my oil i have gaz in the oil pan can you tell me what could be the problem i put new oil but i did not try anything yet you may have a faulty needle valve or a broken float in the ...

generator stalls out when auto idle switch switched to on position. It sounds like a blocked jet and or carb issue, may need to service the carb

generator to power my carpentry tools and the motor kept running but it would not run my saws. With no load on the generator, take a voltage reading at the output plug of the generator, if there is no