Question about Sound Products DJM-1 Microphone
microphone down the shaftto the connector that plugs into the mixer . the wire came disconceted from the connector. now to fix this i would need to soilder them back one the wire colors are white, red
need wiring diagram I need the wiring diagram for the Astatic 636L. Randy [email protected] 4 pin- 1-shld&blue 2-white 3-red 4-black 5-pin- 1-white 2-shield 3-black 4-blue 5-red
...wiring I need the hook up schematic for the Shure SM2 headset with microphone. I am building a box with volume and on/off for our church. Thanks! John Bell Headset connection: Blue wire to Pin 2, ...
Question about SM2 Professional Headset
wiring a Diesel Microphone model 360-100 ,5 wire microphone to Cobra/Galaxy 4- pin radio hookup. Wiring on the Mic is 1-yellow, 2-black, 3-white, 4-black, 5-red. What goes on Cobra/Galaxy #1, #2, #3,
Question about 636L Noise Canceling Microphone Microphone
...wiring drigram for a tristar 120 all the wires have came off.... need to know which wires go to which numbers..... here is info your looking for-for a 636l to a tristar 120 -is as follows-1-audio, ...
Question about XM1800S Professional Microphone
microphone connectivity with 3 pin XLR (cannon) style plugs. It depends on where in the world you are as to the favoured standard, Your microphone usesthe following:: Pin 1 ground (white) 2 +ve or hot
microphone. If that doesn't help, Try turning it in to remove the jack and examine the wiring. Do this gently. There should be 3 wires on this jack. It is an XLR jack. The wires should be 1= ground, 2
...The wiring is 1= ground/shield, 2=hot(+ve), 3=cold (-ve). Do not bridge any of the pins especially not 1 and 3 if you are using phantom power with this microphone. Let me know if this helps
...microphone wiring Need wiring schematic or guide for the 4 microphone solder points correlating with the 4 microphone cable wires (1 black, 1 red, 1 tan/orange(?), 1 ground wire) for the Vtech ...
Question about SE2200A Professional Microphone
...microphone is working correctly, use heat shrink tubing or electrical tape to cover the soldered connections and provide strain relief for the wires. Note that some microphones, including the Sadelta ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions