Questions & Answers for: my mic volume Music

Question about Xenyx 1832fx Mixer 18 Input 32 Bus with Efx USB

1 Answer

mic volume to main mix volume! when I turn up the volume on the main mix the mic also goes up. I need to know how to separate the mic volume from the main mixer levels that controls my music to the pa

Ad

Question about Xenyx 1832fx Mixer 18 Input 32 Bus with Efx USB

1 Answer

...volume up. any ideas? thanx! Proper placement of mics versus the speakers of a PAS is important to avoid feedback. Your speakers need to be toward the audience from where the mic is. If the mic can ...

Ad

Question about Cm500 Headphone With Built-in Mic

1 Answer

is monaural, not stereo. You may have to use a 1/8 jack monaural to stereo jack/plug for the mic. Be sure and set the volume levels for both the mic and headset in the control panel AND UNMUTE the mic

Question about NK 2000U

1 Answer

mic inputs, they both have echo, even tho I turned off the echo volume in the back. I assumed that by turning it all the way off, that there would be no echo in the mics, but there is no difference in

Question about Loudbox Mini Acoustic Amplifier Amp Acoustic

1 Answer

...volume from mic input even with Gain and Master turned full on You haven't told us what type mic you are using. If you are trying to use a condensr mic with this, you will need a preamp that ...

...voice live ; on the mixer set the gain control to 12 o'clock position and individual channel volume level to 7 ....raise the master volume slider to hear mic input at desired level and without ...

...is on. When you find it, click on the "advance" tab and there will be a check box allowing you to add 4db to the volume of the mic. Also, make sure it is plugged into the line in or mic input on

Question about Xenyx 802 8-input 2-bus Mixer W/ British Eq !

2 Answers

...mic volume doesn't show up you can open "audio properties", and somewhere there you will see a tab under "recording" that says "volume" and click the "advanced" tab on the mic volume and it will open ...

...mic.volume" (T-7) full clockwise. 2. Press "MIXER" (C-7). 3. Press "<" (R-17) while is shown "MIXER PART>:EXT(M/I) 4. Set (check) Part [ ON] Volume: [80...127] ... .... N.Tresh [0] If after ...

...mic into channel 1 with volume all the way down. Speak or sing into the microphone and adjust the GAIN until you see the clip light, then back down a litttle on the gain. Put the monitor and main ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...