Questions & Answers for: metal gear box plug

...gear box. Just turn it out and wipe the metal shavings off it and fill the gearbox with the required gear lube until the lubricant just barely seeps out and that's the fill level. Plug the gear ...

...check for heavy metal stuck to the magnet. I suspect that the clutch in-put shaft bearing has failed. If so you will have to have the gear box rebuilt as the metal will have affected the other ...

...gear box from wear and being loose effectively trying to select 2 gears together If the selection is in the top of the box pull the lever and see if there is a small plastic cup on the end of the ...

metal filings in the gear box so go slow and the oil will catch and hold the metal . when you have finished then drain the oil and flush the box several times with say diesel fuel . Put the drain plug

...metal noise 5th gear doesn't work While on the freeway driving about 70 mph pop loud metal noises happened. I can shift 1st, 2nd, 3rd, but 4th and 5th are rough to shift in (while idling). check the ...

...gear which is in the main box indicates a chipped tooth or problem teeth on the lay shaft or synchro dog in the box. Check the magnetic plug of the box and if there is metal evident then the box will ...

...metal bits as this indicates bearings or gear problems. Replace the plug. About half way up the side of the box you will find another plug. Remove it. The oil you are using should be to makers specs ...

...metal box all the way across to the right side of the machine and plug into the 10Sub PCB. You will have to remove the metal lift mechanism and unplug to cables from the 10Sub PCB. You will also have ...

...gear box for metal parts it is an indication of possible bearing failure or the dog teeth of the syncro drum are worn to a taper and are being forced out of engagement under load make sure that the ...

...gear synchro dogs teeth are worn and not fully engaging possible housing is misaligned or rear bearing failure check for metal bits on the plug magnet it may require a box out for a partial ...