Questions & Answers for: mazda 626 front axle

...mazda 626 with a fairly new rebuilt tranny in it approx 500 miles on it. someone replaced the left axle with a new one. when the car is put under a load (pulling out kinda hard or going up hill) the ...

Ad

Question about 1999 626

2 Answers

...mazda 626, when you turn to the right and when you first pull out, you can hear something popping on the front ledt side of the car. it kinda sounds like the axle. any help on this matter would ...

Ad

Question about 2000 626

1 Answer

mazda 626 pulling front cv axles out of mazda 626 2000 ive got the outer part of the axle loose from the spindal side but cant get the inner loose from trans help please First put a jackstand under ...

mazda 626 popping noise in front driver side when turning and or body shifting Your Constant velocity joints have gone bad. the Boot that holds th grease has leaked out all the grease and the bearing ...

Question about 1993 626

1 Answer

...front end of my mazda clunks real bad and loud, while turning the wheel at any speed. Both directions. Help! Check boots on CV joints for tears. Torn boots result in CV wearing out. The boots are at ...

Question about 1997 626

2 Answers

...mazda 626. some transmission fluid leaked out and I need to know how and where to refill it.. Any advice would help do you have a dip stick to check your fluid leval if so you fill it there On the ...

Question about 1994 626

1 Answer

...mazda 626 w/auto trans. Front end is off ground and supported. After removing drivers side axle shaft, I replaced it with a new one and while installing it turned it a little (enough to move wheel on ...

left front tire is making a clicking noise when accelerating just changed axles sounds like the bearings in the axle all it takes is one mess up to knock one of those little bearing out .

...mazda 626 front axle shield broken The drive shaft has to be removed to replace the rubber boot .you will have to dismantle the CV joint , clean and repack the joint with special grease and fit a new ...

...mazda 626 to a 97 mazda 626? Looking at ordering the CV joint it's all the same parts, I just want to be sure the full assembly will mount the same. You install a complete reman front drive axle If ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...