Question about Neptune MAH5500B Front Load Washer
My washer clangs and dances like crazy!!! I thought my struts had worn out, the front boot is also torn from this problem. New struts and front boot. Still appears to be posessed by the devil!! Is ...
...Maytag. Good luck! I just went thru my 10th load of a mix of light, medium and heavy loads and all work fine no unbalance errors (DC/UC). Doesn’t fix the tangle problem :) Prior to this fix I ...
Question about Neptune MAH5500B Front Load Washer
Maytag Neptune front load washer with FL code Have done two loads with no problems. Then when I shut the door and started the washer, it beeped saying the door was open. Door is locked, so cannot open
Question about Neptune MAH6500A Front Load Washer
washer only stays on a few seconds than off. After pressing the start switch the washer only stays on for a few seconds than off. Hi Endorphin, Most will tell you that you have a failed start switch..
...Sensing" .... I decided to try something else. I powered it off and started a new load. Next Load Trial: I added soap to the detergent dispenser " Not the detergent smart dispense. Then i pushed the ...
Question about Neptune MAH5500B Front Load Washer
May tag Neptune washer will not stay locked Model ma5500bww it may be a bad door lock or it senses a problem. error code? tech sheet may be in console some had them below.
Question about Centennial MTW5800TW Top Load Washer
...sensing light stays on. I have unplugged it and left it for up to 3 hours. When it is plugged back in, it does the same thing. Sounds like the lid lock itself is bad, be sure to check the connections ...
Question about Centennial MTW5800TW Top Load Washer
maytag contennial washer sensing and lid locked lights are flashing and it won't wash LID LOCK LIGHT STAYS ON NO START: Usually either the lid lock mechanism, the lid lock actuator or the board is the
Question about Centennial MTW5800TW Top Load Washer
...washer Maytag press start button it begins its sensing mode locks lids and doesn't go pass this mode. Lid locked lit keeps flashing and sensing lite stays on Most likely actuator is bad or drain Pump ...
Question about Centennial MTW5800TW Top Load Washer
Maytag Cent. Washer MVWC400XW3, stuck on SENSING and LID LOCK I replaced the Door Lock and Actuator - still getting the same results as I did before I made any replacments Maytag Centennial Washer ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions