...neptune), and if the idler pulley is about 4-in diameter you have chosen the hardest dryer to replace a belt on. There is a diagram on the bag your new belt came in. The door in the back of the dryer ...
Maytag Neptune MDE3000AYW. HELP!! :) FIRST, OPEN THE DOOR AND REMOVE TWO PHILLIPS HEAD SCREWS ON EACH SIDE OF THE OPENING. TWO GO THROUGH THE HINGES, AND TWO ON THE OPPOSITE SIDE OF THE OPENING. THEN,
...belt is on (so you can get the new one on properly) and reach in and take the belt off the motor, there should be a tension pulley holding it on. then slide the drum out and out with the old and in ...
Question about Neptune FAV6800AW Top Load Washer
Maytag Neptune FAV6800AAW? http://www.ehow.com/how_5649680_change-belt-maytag-neptune.html Remove the back plate of the the washer. Loosen the 1/2" bolt that holds the motor to provide a little "play"
Question about Neptune MDE5500AY Electric Dryer
new belt 1.Unplug the electrical cord of the Maytag electric dryer from the electrical outlet. 2.Open the dryer door and locate the four screws on the inside,unfastening the screws with a screwdriver.
Question about Neptune MDE5500AY Electric Dryer
...new drum rollers for your machine. Follow the directions below if possible: ALWAYS UNPLUG YOUR DRYER BEFORE STARTING ANY REPAIRS Your problem sounds like drum rollers have flat spots on them or in ...
Question about Neptune MDE5500AY Electric Dryer
...Maytag Neptune dryer from the dryer electrical outlet. 2. Open the dryer door, and locate the four screws on the inside lip of the door opening. Use a Phillips-head screwdriver to remove the four ...
...Maytag Neptune MDG5500AW and turned on the dryer only to hear a screeching sound the moment the dryer drum started turning. Thought it might be the belt and/or rollers so opened it up and found the ...
...Neptune dryer drum.7Route the new dryer belt around the drum and along the pulley system. Release the idler pulley to restore proper tension in the belt. Rotate the drum to ensure the belt is ...
Question about Neptune MCE8000AY Electric Dryer
idler arm fell off when putting the new belt on, the clip and the arm. how can you put that back on? It slides under the model and the end slips into a loop made in the base
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions