Questions & Answers for: maytag mde9700ayw control board

control board is open.Try taking the following action 1.Make door is closed. 2.Check for loose wire connections at switch and/ or machine control board. 3.Check for failed door monitor switch. 4.Check

...Maytag Neptune Dryer that won't heat. we replaced the thermistor and the control board. What else could it be? First unplug dryer and test your heating element for continuity with a multimeter if it ...

...mde9700ayw and it stops and gives the code hE This error means there is an issue with with the heating portion of the dryer. Could be the thermistor, or the element, or the control board. You have to ...

what is the code upside down F and a 5 ? It is a TS error, I thought the same as you that it was aT5...lol...Anyways it is either the Thermester or the controller board. If you can afford it get a ...

Maytag Neptune MDE9700AYW does not work. Faint clicking of a relay is heard with connected to power source. No lights or codes on the control panel. Was told that the "CCU" needs to be ...

...I am getting a code that Maytag says doesnt exist. My appliance guy doesnt know how to resolve as no wiring diagrams. E5 is usualy logic controler failure a fancy way to say replace the control ...

...control board is defective. Remove the board and check the connectors and the wires from the board. If there is dry joints or loose connections this is possible, only if the machine works erratic. If ...

...maytag neptune front load dryer model #MDE9700AYW shows a T5 code and will not heat. I found that the code indicates an issue with the thermistor, but I checked the thermistor and it ohmed out ok. I ...

control board making ticking sound Hi, I am pretty confident that I've narrowed down my problem to interior control board. The large capacitor on the board was "puffy" or raised. Under the advice of a

...Maytag Neptune MDE9700AYW doesn't have power to the control panel. The light inside the unit works so I know there's power. I checked the thermal fuse and it's showing continuity. Any suggestions? ...