...maytag legacy series top loader. I have a presumed main bearing seal leak. However, I can't seem to figure out how to remove the round "disk" above the seal. (the one with the shaft going through it) ...
...maytag legacy will not spin out the water. The drum spins fine. Check the drain hose and make sure it is not plugged or kinked. Check as well that pumps spins. Good luck Just looked at mine the belt ...
Maytag Legacy We have determined that a nail or screw is stopping the spinner from spinning! How do I take the drum and drum liner apart? Need a special tool to remove the lock nut on the spin tub the
Question about Neptune FAV6800AW Top Load Washer
MAYTAG LEGACY SERIES STARTER BUTTON? WHEN I PULL IT OUT TO START A WASH, NOTHING HAPPENS, IT SOUNDS LIKE THE POWER IS ON BUT WATER DOESNT START FILLING UP(NO MATTER WHAT CYCLE) control panel removable
...maytag legacy series, toploading washer. It does fine, until it spins...a very loud screaching sound. Could this be a belt? most likely your problem is in the pump either the pump itself is bad or ...
how to remove the pump on a Maytag SAV205DAWN Either remove the front cover or turn themachine over,to get to the pump.Easy job
maytag legacy starting and stopping My machine will click on for about 20 seconds every 20 minutes and then stop. It never advances in the cycle and if I change to a different part of the cycle the it
spin cycle wont work Plug on motor (Multi-plug) has a burnt out wire as it has different speeds. Remove and check the plug (top comes off). Any burnt wire needs to be cut back to clean copper and ...
Question about Legacy Top Load Washer
...maytag legacy. 9 years old. getting worse over 3 months. removed front and rear panels, dried out and looked for leaks. only water was on agitator base. im thinking tub bearings and seal. any other ...
Question about Legacy Top Load Washer
Maytag dryer model # SDE305DAYW Legacy series? everything i am reading says remove the lint trap and then unscrew screws BUT my lint trap is on the bottom and when you remove it there are no screws? i
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions