Questions & Answers for: maytag ice door wont open

...ice chute door flapper seal to make sure warm room air isn't being drawn into the ice bin area. Also make sure the freezer area is VERY cold like 0 degrees F or lower, that will keep the ice hard and ...

door (should just lift off), and ice maker first. Remove vent in center of freezer panel by pushing up little tab in the center of the vent and using a screw driver to pop it loose on each side of the

skybox wont dispense i checked low product switches main board has both led lit fan not working look for ice blocking the door on the unit and causing it not to fully open , good luck

...ice comes out on the door,or turn the freezer setting down say from 4 to 3 and after a couple of days it should be fine There is an electric solenoid valve that is located in the rear bottom of the ...

ice box temperature as well, it often says 1-10 and off as well, the reamaining setting, the one that cannot turn the compressor motor either off nor on is a damper door controller, that modulates the

...wont cool dont know whats wrong The fridge gets its cold air from the freezer through a vent(damper) between the freezer and fridge.The fan in the freezer blows air through it. Make sure this fan is ...

...door is not opening up or it has accumilated ice in it and frozen up. I would try to unplug it for a hour or so with the doors open and let it thaw and then plug back up and let it run for a couple ...

Maytag model # psd262lhez REMEMBER GOD IS THE REASON FOR GOOD ADVICE" FREEZER /FRIDGE NOT COOLING: Optimum refrigerator temperature at or below40° F(4° C). The freezer temperature should be0° F(-18° C

ice build-up on the inside walls, floor, or ceiling of the freezer. Such a frost build-up usually indicates a problem in the self-defrosting system or damaged door gaskets. If one of the components in

...maytag refrigerator is not cold ,no cold air blow from the freezer I suspect ur evaporator fan went out? or is blocked due to a defrost issue? Check ur cold control thermostat, ur thermistors in both ...