maxtor N256 13gig HD, model # 91361U3 and the bios does not see it. Need to set jumper to master and have no guide on drive. Can you help me? The second pair joined (jumper) I suspect it is configured
...n256 Maxtor Maxtor jumper settings link: http://www.seagate.com/images/support/en/us/mxo_ata_jumpers.gif Second link: http://www.seagate.com/staticfiles/images/support/en/us/mxo_ata_jumpers_rev.jpg ...
...Maxtor N256 The first jumper goes up and down on the two pins just beside the IDE cable slot and the other jumper goes across the top two pins next to it ...
...maxtor n256 diamondmax vl 40 5400 rpm There is usually a diagram on the drive showing the jumper configuration. I tried to make the Jumper setting for maxtor n256 diamondmax vl 40 as slave like the ...
Question about DiamondMax 80 (96147H6) 61.4 GB Hard Drive
...maxtor N256 master with slave I'm trying to get the jumper settings for a maxtor N256 (model 96147H6) that I want to use as a master with a samsung SV1204H as a slave. I have the settings for the ...
...maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on the top of the Maxtor drive. ...
Maxtor N256 Jumper settings Here's a link to them on the Seagate site... (Seagate acquired Maxtor) http://www.seagate.com/staticfiles/images/support/en/us/mxo_ata_jumpers_rev.jpg All Maxtor hard disks
...maxtor n256 model 90510D4 jumper settings Check this diagram. it shows all configuration in detail.. good luck!! Look here: ...
...Maxtor N256 Hard Drive I have never personally seen one but most drives are the same for the type of jumpers installed. See if this helps you: ...
maxtor hd jumper settings n256 91366u4 primary MAXTOR: no jumpers --> Master one jumper --> Slave two jumpers --> Cable Select
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions