Questions & Answers for: marshall ms 4

wiring diagram pignose 7-100 guitar amp which wire goes where? There are a couple thumbnail sketches of the diagram at: http://music-electronics-forum.com/t8790/ They are down about 3 an 6 of the ...

...get the clean sound good, then work on the gritty sound. The amp is voiced for a sweet clean sound - if you want grit'n'ball change to a 50w Marshall valve head and a 4 X 12 cabinet. Horses for ...

...switch power switches are pretty easy to replace, i have the mgdfx50 and its only 4 spade connectors, 2 blue and two brown, doesnt have to be a marshall, just a 4 pole switch from an electronics ...

...marshall avt50 head.....total impeadance is 4 ohms. can i connect 2 seperate 2x12 cabs rated @ 4 ohms each? i want to get maximum power but want 2x 12 option for either side of stage. No, the ATV50 ...

...to amp works well.(AMP is Marshall MS-4) What is the problem. Thks there should be an input, and an output on your pedal, the connections should be : guitar to pedal input, pedal out put to amp

Sound fades. Clean channel has some overdrive in it at all volumes. After 10 minutes, sound starts fading, both clean and overdrive, and keeps doing so. I suppose it's an overheating thing. Any ...

...Marshall Mode 4 amp to not change channels? When the pedal is plugged in, it will not change from "crunch" mode. Both the clean and crunch lights are on as well. Again, it is a Marshall Mode 4 guitar ...

...4 months old Marshall Woburn speaker won't turn on? What can be wrong with it and when're can I get it fixed ? Worked fine yesterday Is it still under guarantee? Can you return it to the dealer? If ...

marshall dsl15h? Specifically, unplugging the solid state head from the speaker to connect the tube head to it. Hi. Doesn't look like it as the speaker is a 4 ohm one and the head needs at least 8 ohm

marshall ms-2 little red lights on but no sound If you're using a power supply, make sure the values are right. If not, try a fresh battery.