Question about SR-7200 Receiver
power light still blinking rapidly. Any ideas? Marantz SR 6001Power and StandBy Light came on and is blinking Rapidly. There is a review at CNET that slams this receiver. Do not Buy. Actually looks to
Question about SR-7200 Receiver
...marantz sr7200 amp keeps keeps going in too standby mode my amp auto goes in to standby mode by itself approx 5 mins after I turnn it on...help!!! I have just received it bsck from having another ...
...the unit. Then hold down Sorround, Exit, Memory & Clear buttons all together and then switch on the power. This should work. marantz sr5004 power led is blinking very fast pls give me the ...
...amp;its showing standby light only.which stage defective.pls give me ans; Regards Anu. hi, check the power supply voltages 5v, +-15v. also check the power on relay driver side. also check is there is ...
...marantz sr5004 is flashing the standby light and wont switch on Switch off the unit. Then hold down Sorround, Exit, Memory & Clear buttons all together and then switch on the power. This should ...
marantz pm 6004 blikining red power standby blinking power standby Are the speakers connected? If so , you have an output DC voltage issue ( typically outputs dont want to see more than 100mV DC going
Question about SR5007 Home Theater AV Receiver
...marantz sr5007? Turn off the power using X. 2 Press X ON/STANDBY while simultaneously pressing PRESET CH + and PRESET CH -. 3 Once the display starts flashing at intervals of about 1 second, release ...
Question about SR7005 Receiver
...power is pressed, it turns on for 2 seconds and then standby lights blink again and it turns off This could be caused by a direct short circuit on the speaker outputs. Try disconnecting all the ...
Question about SR7005 Receiver
Marantz SR5006 won't stay on. Unplugged all the speaker banana plugs. Faulty power supply? Or faulty amp circuit. That is what Id check first. How fast is the standby light flashing? Slow, around once
power amp circuit board no longer available from Marantz. I figure changing the fuses is the next logical step, before removing the amp circuit board and having it bench tested. Haven't found anything
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions
