Questions & Answers for: mantis pull cord replacement

...Mantis tiller Cord snapped. Any way I can fix this myself? Should I try to open the housing? Good job on the cord replacement. Most people take the cover off the spring and then find out it is nearly ...

...pull cord on a mantis tiller? Replacing the spring on this tiller can be tough. You have to get the tension spring set into the stop and partially wind the tension (by turning the cord pulley) and ...

mantis tiller will not start was working until it ran out of gas yesterday, found that primer bulb was busted, husband replaced bulb but now can not pull cord to start did it also run out of oil, ...

...pull cord on tiller. trying to put a pull cord on 5hp briggstraton tiller please help. you remove the cover, bend three tabs and the wheel will come out. Replace the cord in the manner that it is ...

mantis will not start - has good fuel and new sparkplug Check spark plug gap and functionality of throttle. I all is OK it could be flooded. If flooded. Remove spark plug and pull cord a helf a dozen ...

pull rope of Mantis Tiller Remove the starter assembly from the side of the engine. Remove the balance of the old cord from the spool and purchase about 1-meter of replacement cord from a saw shop (it

...pull it out. First, call Mantis and get their advice. It may be covered under warranty (I believe it comes with a 2 year warranty). If not under warranty remove the spark plug and try to pull the ...

...pull cord remove top starter assy. cut grip from old rope ease rope into spool, when slack remove center screw and carefully pull out spool, tie knot in rope and thread into spool, wind rope [make ...

...mantis pull starter? I need to replace the one on my tiller and the rope I have is to large go to any small engine place and they will fix you up I am guessing but I haven't seen any recoil starter ...

...Mantis tiller is hard to pull, there are a few potential causes: Engine oil level: A low oil level can cause increased friction in the engine, making the cord harder to pull. Check the oil level and ...