Questions & Answers for: makita drill wont turn

...makita uses plug BPMR7A, sometimes i find a BPM7A in it) if everything looks good, i'm sorry to say you're going to have to remove the cylinder. remove the filter cover and starter coil remove the ...

Battery charger shuts off when you put in a battery to be charged,reset wont work,unit is getting warm-a Short ? I have this problem with my black and decker when I tested the leads in the charger ...

Makita 18 v impact driver. 16 months use and from last week occasionally wouldnt start. The led lights but wont drive either direction. I turned the driver by hand and it will kick in- like there is a

...drill and take a look all the parts pretty much stay in place see if you can turn the motor by hand if it wont turn use some 3n1 oil on each end of the motor that shooed do the trick hope this helps ...

makita bhp453 chuck screw wont loosen cant move screw turning clockwise but wont budge The chuck screw on drills is put in with lok-tite and is reverse threaded.  You need to get the screwdriver ...

...drill switch is causing this cause the packs work in every other makita tool i own once re charged. odd thing is the pack can be fully charged and when i put it in the repaired driver i pull the ...

...Makita 8406C core drill which Hums but wont turn., I have replaced the brushes and cleaned the armature but to no avail. I am looking for a wiring diagram for The makita 8406C or suggestions for ...

...wont work ln low gear I KNOW IT !!! MAKITA the first gear is damaged the notches in the gearbox (planet-transmission)are grinded away about 2 or 3 mm are left and the gear shaft will not fit in the ...

...drill wont spin it just smokes and buzzes theres power to the drill but it wont spin properly and just makes a loud noise and smokes as if its jammed up. i've cleaned all the contacts and the motor ...