...makita cordless and the gear box slips and grinds when very little pressure is applied. I took the gear box apart and it is all plastic. I think I will invest the $50.00 dollars into a better drill ...
Makita 12v starts intermittingly Strong drill had for 10 years it stops and starts...could it be the battery? i would say its the switch! but i would jump the motor directly to the battery bypassing ...
Question about 18V LXT Lithium - Ion Cordless Impact Driver Kit Model BTD140
...makita drills and this is happening with all of them First, check the lever on the top of the drill (high/ low lever speed) and make sure it is engaged in one of the positions. If it is in the middle ...
Question about 6019DWE 3/8 Cordless Drill Keyless Chuck Rev 7.2v 600 Rpm
makita 7.2 volt cordless 6019d chuckless drill. thanks As long as the charger voltage and the battery voltage match (7 volts) there should be no problem. A fast charger just runs more current thru the
Question about 3/8" Dr. 14.4V Cordless Drill Kit
...Makita cordless impact driver which was working great until I got near the end when the slower speed setting (half-trigger) stopped working and the driver only ran at high speed with the trigger ...
Question about 9.6v Cordless Impact Driver 6903VD
Makita modle # 60930 driver drill that stopped working. Battery OK. took apart and switch worked. Tried to put back but a couple parts fell out. Need to know where they go. Ome is a small black washer
...Makita cordless drill, model 8391D. Whilst drilling a pilot masonry hole it suddenly stopped. The battery had only just started to slow so I changed it anyway to a fully charged one and the drill was ...
Question about 18V LXT Lithium - Ion Cordless Impact Driver Kit Model BTD140
green flashing light i plug carger in put battery on it runs for about 5 seconds then stops then the green light starts flashing battery is open circuit or charger not working Re: Jeff
Question about 6337DWDE Cordless Drill
while working the drill will suddenly stop and then when i shake and tap battery it will start working again Hello Beverly, I would check for worn out brushes.
Question about 6337DWDE Cordless Drill
Hi I have a makita cordless planer and the electric brake seems to have stopped working, cand this be repaired or do I need to change the brushes you need to replace the brushers
Usually answered in minutes!
378 Questions
257 Questions
252 Questions
238 Questions
190 Questions