Question about Brad Nailer Finish Nailer Compressor Kit
...makita brad nailer,the F-nails or T- nails,im using the T-nails now and it seems to get stuck just below the drive blade,its driving my crazy! is that a model AF505? if it is, your problem may be the ...
Question about 4351FCT Barrel Grip Jig Saw with L.E.D. Light
blade stuck in makita 4351 jig saw cant remove Take the set screw that holds the blade all the way out. Then take a ice pick or small flathead screewdriver and work the broken blade out.
stuck The blade lock lever is stuck in the "unlock" or open position. Is there a way to fix this (without voiding the warranty or having to take it in for service? I just purchased this 2 days ago and
...blade is on correctly. If there is something stuck between the blade and the mount it will make everything off. Or if the but holding the blade on is not on tight enough you will have the same
Question about LS1013FL 10" Slide/Compound Miter With Laser and Light
...stuck or attached to the saw this fits the bolt that secures the blade the bolt that holds the blade turns left handed so most bolts turn righty tighty lefty lossey this is oppisite turn it clockwise ...
...blade into my makita JR3000V reciprocating saw. It seems like the blade is too thick and I can't get it out. How do I get the blade out? lock the blade in a vise or grip it tightly and with ...
Question about Jigsaw Blade
...(Tooth set means the tips of the teeth are bent a little bit to the left or right to make the cut just a little wider than the rest of the blade so that it doesn't get stuck in the cut.) Good
Question about Tools 12" Compound Miter Saw - LS1221
...stuck at 45 degree bevel to the left, could someone give me a hint. thanks a lot Adjusting the miter angle involves two cast surfaces sliding against each other. If those surfaces have some ...
Question about Tools 12" Compound Miter Saw - LS1221
I have a 4340 makita jig saw with a keyless chuck and I have a blade stuck and can't get it out . Any suggestions push the collet retainer hard up on the shaft and the broken bit will fall out
...Makita ls1214 cross cut mitre saw that was being borrowed. The saw jammed and when the jam was cleared there was reportedly a small puff of smoke from the back of the motor. However having got it ...
Usually answered in minutes!
317 Questions
162 Questions
122 Questions