Questions & Answers for: makes brake pedal hard 1996

Question about 1996 Ram 1500 Club Cab

1 Answer

...cruise ? I would start at the switch down at the bottom of the brake pedal, then wiring, and go under hood and make sure nothing has happended to the cruise assembly. Please elt me know what you

Ad

...quit, bulbs are good, all other lights work, 1996 Doge, 1500, 2wd have you checked the brake light fuse and if so then yoou should check for power in and out of the switch located on the brake ...

Ad

Question about 1996 Ram

1 Answer

...Brake pedal depresses to floor when making a full left turn or right turn. Replaced master cylinder 4 times, brake booster, brake proportioning valve. all master brake cylinders was bench bleed, the ...

Question about 2007 Ram 1500 Quad Cab Sport

2 Answers

brake pedal a indicator alarm sounds, I am getting no lights, and the truck seems to be running fine. I have turned the truck off and then back on and the alarm still sounds off if I step on the brake

Question about 1996 Ram 1500 Club Cab

1 Answer

...brake light switch at the pedal. Any thing elser you can think of? REMOVE THE RED LEAD FROM THE BATTERY THEN REINSTALL IT, THIS PROCESS IS EXCELLENT TO SOLVE INTERMITTENT PROBLEM SUCH AS YOUR. IE. ...

Question about 1996 Ram 1500 Club Cab

1 Answer

...brake pads, pedal goes to the floor, no air in lines, found leak, apperas to be halfway back, above fuel tank... What's back there that is causing a leak? Only thin I did is change the front pads... ...

Question about 1996 Ram 1500 Club Cab

1 Answer

...brake pedal for cold side of switch for trailer brake controller hookup if you have a test light then check for voltage at the wire that only has voltage when the brake is applied that is the wire ...

Question about 1996 Ram 1500 Club Cab

1 Answer

...your getting power to the tail lights make sure you have a good ground if your not getting power to the tail lights could be the tail light switch usually mounted on the brake pedal...hope this ...

...brake pedal when applied with the engine running. A quick test for the vacuum assist booster is to shut off engine, pump brake pedal 3 or 4 times and hold on the last pump, start engine and see if ...

...goes down further and the brake switch functions. When running and booster is working pedal does not go down so far and light switch is not released enough to work. Adjust light switch at brake

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...