Questions & Answers for: low and high on a chainsaw

...066 MAGNUM CHAINSAW JUST WONDERING IF YOU CAN TELL ME HOW MANY TURNS THE MIXTURE SCREWS SHOULD BE SET AT one turn high and low 66 has compesator carby willrun rich up high but will lean under ...

...high and low I have a poulan 2550 chainsaw trying to to set high and low fuel settings starting settings are 1 turn on high side and 1 turn on low side.most likly you will be at 1 1/2 on low side and ...

...low. Your high adjustment idle screw needs to be adjusted. Firefishin is right I have a Stihl 028 Woodboss chain saw and of had the same problem until i touch the low idle screw it sloved my

LOW and HIGH speed screw settings what are the LOW and HIGH speed screw settings for a Ryobi RCS4040 Chainsaw you those to adjust the carb hi is balls out running , sometimes it sounds sick or ...

high, and low.. if you look air filter cover you will usually see three holes and the high and low will usually have plastic covers on it.. adjust the low 1/4 of a turn and the idle screw in about 1/4

high and low adjustment screws;however the cover over the carb. seems to have an effect before and after adjustments are made to the general performance of the way she runs once warmed up. my question

low), H (high) for fuel injection at low and high speeds. There is also a minimum (the chain must be stationary if it is well tuned). The chainsaw is set at low rpm throttle with screws ( L ), and its

to set you low end.  The high end of course would be set with how high you want the RPM. With this side of it you need to check the manufacturers notes for how high. Too high is bad for the motor

...high/low i need the high/low settings for the carb. older 33cc with 16" blade Homelite 33cc 16inch Hi, most chainsaws start with carb settings at 1&1/4 turns out( hi+lo) usually once the ...

...a eager beaver 2.0 chainsaw turn both high and low screws in. now back the low screw out one full turn now the high side 3/4 turn unit should start at these settings now run engine and fine tune ...