Questions & Answers for: loose stove top

...loose and unplug the the wire harness that connects the burners to the rest of the stove.then all is disconnected so lift entire top off from hinged area and set upside down on table.transfer all ...

The breaker is tripped. The GE Stove Top breaker is tripped. Replaced the breaker, but it tripped again. Turn off the power and check for bad or loose connection where your GE Stove Top plugs in.

...loose you may be able to use the butter knife method mentioned in step 1 but you will have to do it from the front of the stove which will be a bit more difficult. All work is performed at your own ...

loose? Hi! Yes it does. If you open the oven door and look up at the bottom of the stove top that overhangs the front of the stove there are two 1/4 inch nutdriver screws holding the top secure. These

spark to ignite none of my frigidare gas stove top burners will spark to ignite There is an ignition module that sparks when it calls for lighting. This module could have a loose connection or be dead

...of them is blown. If that is not the case then one of the wires has come loose either in the service panel or in the outlet behind the stove. Use a multimeter to check the input voltage at the

...esp. when pre-heating. Stove top works fine but if using oven and stove together the problem is worse check if there are cracks in the element or if it is loose could be overworking or shorting ...

...stove knobs won't turn on the oven. If you've already checked the igniter, take apart the top and look for loose wires. My husband found a loose one going to the control board, tightened it and now ...

...the back panel and inspected it, open underneath the stove eyes and inspected. Nothing loose or burned. Where do I go from here? Does this stove have fuses . if so one or more could be burnt

...stove usually in the top of the temp control dials probably a flip lid to access Check the power coming in connection splice. Loose electric connections tend to heat up, burn themselves disconnected ...