Question about Mesa Gs Mountain Bike
...crank bearing on my Schwinn Mesa Mountain Bike. I think it is damaged, the assembly is loose and makes a clunk/sort of grind noise. Any help would be greatly appreciated! You wil need a couple of ...
...LOOSE IM TOLD YOU CAN NOT BUY BIG END BEARINGS THE COMPLEAT CRANK WILL NEED REPLACING, IS THIS CORRECT, OR IS THERE AN ALTERNATIVE SOLUTION, THANKS I think honda only sells the complete crank as you ...
crank is loose. If you find the pulley loose, if the bolt holes are not elongated, just tighten it back up. If the damper is loose, remove it from the engine (puller usually necessary) and inspect the
...loose.. moreso the crank where it bolts to the frame, it is held together by a pivot bearing. the pivot bearing alan screw is tight though which makes me wonder why it's still loose.. obviously ...
87 chevy blazer has a knock Causes of engine knock are worn piston pins, loose pistons due to scoring, loose rod bearings or loose crank bearings. Last but not lease is carbon knock
...of the following problems 1-- loose/ failed big end bearings 2-- broken rings 3-- loose gudgeon pin bearings 4--failing main bearings 5-- something that the crank shaft is hitting as it ...
Question about Marathon Carbon Expert
...crank, bottom bracket and shaft are loose. if I tighten the bottom bracket rings then the crank is too tight to rotate. And it makes a grinding noise when you pedal, sounds like rocks grinding ...
Question about 2008 Bantam 1.3i
...crank bearing- bearings install wrong -wrist pin damaged -piston damaged just changing the parts in block with out inspection or prep ]cylinder honing-crank journals checked ] is putting new parts ...
Question about 2008 Bantam 1.3i
...crank is loose and/or the bearings inside the bottom bracket are worn. There should not be any wobble in the cranks and they should spin freely, without noise, when spun with the chain off. Tighten ...
Question about 2008 Bantam 1.3i
...crank is wobbly and shakes up and down what do I have to do and do I need any parts DO I NEED ANY PARTS LIKE BARIENS Check the big nut on it and see if it is loose? If not the bearings inside need to ...
Usually answered in minutes!
165 Questions
193 Questions
115 Questions
114 Questions
96 Questions