Questions & Answers for: location blower resistor 2004 dodge

...blower fan only runs on high then resistor located on passenger side no good, which could mean fan was binding. Carla, The common factor to the A/C , defroster (front) and heater is the blower motor. ...

blower motor resistor where would I find this blower motor resistor thank you The blower motor resistor will be on the Fan mounting backplate,,it will usualy be mounted in such a way as to be in the ...

...blower all of a sudden just stopped. can you tell me what it could be? Check for a blown heater motor supply fuse, Check operation of heater motor control relay, Check operation of fan speed control ...

...blower resistor and the wiring at the connector to resistor its located next to blower motor, they have problems with the connector to risistor bruning and melting, il bet that your problem , start ...

...blower motor resistor. location for resistor is behind the glove box. Remove all items in glove box. remove glove box from dash and to the left of the blower motor you will see a electrical plug, ...

resistor switch for the blower but cannot locate where it goes Your blower motor should be up under the dash on the passenger side. You probably have an access point that you can take off and drop the

Blower Motor Resistor I have,a 02 dodge neon when i went threw water yesterday I blew my asd fuse .but when I replace it.it crank right up but when I go throw water on the road it shut down. Under the

...blower motor resistor on a 1999 dodge durango Front blower stopped was coming on occasionally,rear blower works fine.Trying to locate the front blower motor resistor most resistor blocks bolt to the ...

...flows from the 25 amp fuse, in cavity 7 of the fuse block, to the blower motor. Blower motor speed is controlled by the fan control switch located in the instrument panel, and by the resistor

...blower fan resistor, and now the blower motor quit. Is there something wrong with the temperature control? The problem was the motor. Replace the blower motor and resister and it should be fine. If ...