Question about 1998 Dakota
...cam position sensor repeat failure 2.5L 4 cyl. engine works perfect then no start. Engine cranks but no spark. Dealer replaced cam pos sensor located in the distributor and ran fine. 13 mos. later, ...
...cam shaft position sensor is located right behind the exhost cam by the fire wall. It is held by two 10 mm bolts, one on each side of the sensor. If you got the hood up and looking at the engine the ...
position sensor on my 1999 saturn SL1, single cam 1.9 litter engine, but can't locate were they are at on the car. I think it's behind the motor inthe middle of the block. A crank sensor can set a cam
where is the crankshaft sensor located on the dodge dakota 99 sport v6 On the V6 and V8 engines, the crankshaft position sensor is bolted to the cylinder block near the rear of the right cylinder head
...cam & crank position sensors for a 1999 chevy suburbon 5.7? THE crank sensor is located at bottom of timing cover on front of engine if you look under engine below crank pulley around oil pan ...
position sensor. Advance Auto etc has these usually in stock for about $50 you do not need to go to the dealer. Looking for a cam pos sensor on the 1999 dakota is a dead end its called the
camshaft position sensor 1999 dodge dakota I don't list a cam sensor for a V6 Dakota because it uses a distributor.
cam sensor or crank sensor, crank sens is located in the bell housing on the pass side and I believe the cam sensor is in the distributor, 740 is a TCC (Torque Convertor Control) performance code. The
where is the cam sensor on a 1999 saturn sc1 3 door located. location of the cam sensor on 1999 saturn sc1 3 door . This vehicle doesnt have a camshaft position sensor, it uses the crankshaft position
Is the cam position sensor located on a 4.7 2002 Dodge Dakota cam sensor is located on the front of the passenger side cylinder head
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions