...inner tie rod on a 2000 dodge intrepid I did this on a 2002 Intrepid, and found that it wasn't too complicated. I replaced the bushings only, rather than the tie rod end. You can get bushing ...
...inner tie rod Does anyone know what size socket is needed to remove the bolt and also what the torque is? Thanks, Troy To Steering Gear Bolt 90 Nm (66 ft. lbs.) Jam Nut 75 Nm (55 ft. lbs.) NUMBER: ...
2001 Intrepid, is the tie rod end located above the wheel and is it a threaded assembly? the tie rod end is at the wheel their is an outer and a inner they are both threaded
...inner tie rod? Not sure If I need a special tool to take off the nut. I used this website: http://www.allpar.com/fix/intrepid-steering.html It worked perfectly. To add to it, I used a tie rod puller ...
...inner tie rod ends. Loosen both. Remove one at a time, replace bushing with kit. Use some synthetic brake grease on the bushings. I recommend Napa sylglide. Replace the bolt, but do not tighten all ...
How do you replace the inner left tie rod bushings on a 98 dodge intrepid? Took it to my friend who is a mechanic - problem solved.
...inner tie rod bushings you need to get it out. get on the engine and go to the back at the fire wall look for the bolt that hold the tie rod there should be a lock washer which is bent to keep the ...
...Inner Tie Rod Bushings. The inner tie rods are up on the firewall behind the engine, have someone turn the steering wheel back and forth (just enough to feel all the play) and see if the rods are ...
...is a lock that is between the two bolts , do one at a time , much easier, unhook outer tie rod remove the bolt for that side then remove it from wheel well , change bushing install then do other ...
...inner tie rod ends, stabilizer bar bushings, lower control arm bushings , and finally a wheel alignment ,you have some bad looseness in one or more of these front end parts. GOOD LUCK FRIEND. 30 ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
