Questions & Answers for: lnb voltage

...lnb voltage out.The outputs are not shorted like a bad zener,just no voltage. Thanks First, verify the oscilador circuit of the power.It´s normal the IC is damage or the mosfet. Second, desconect the ...

No LNB voltage No satellite signal what model and you can have voltage and still no signal.

...lnb. voltage at sat in connector is 7.5 volts, but with lnb connected voltage drops to less than one volt. Is there a dropping resistor in that circuit or what may the problem be. no shorts in rf ...

...LNB. As a fail safe check that your mount is level and plumb. You also may have the dish pointed directly at 119. Check the Skew and elevation settings as well. If LOS IS THE ISSUE YOU MAY NEED TO ...

...H should have 18v. The skystar does not send the voltage of 18V to switch the polarization of LNB. Does anyone know any solution? Thanks in advance Technisat - Skystar2 Rev 2.3 i have the same ...

...lnb voltage would also cause the receiver to lock up after a few hours consistantly? I have two of these and the one that is locking is the one with the low voltage. The unit does not find any sats ...

...voltage regulator, try to locate where the 20 volts line from the power supply and follow it to anywhere near the LNB tuner circuitry. This type of IC is normally mounted on a heatsink. Lastly if you ...

...LNB appeared to of went bad again. This time i measured the voltage to it and it was 33 volts instead of the recommended 13-18volts. if you take the cover off the receiver and look at the power board ...

LNB voltage. i checked the voltage of LNB input socket , it is nor 13v neither 18v.now i want to know is this the hardware or software problem. please help. thanks in dvance. Hardware. Check the power

...LNB connector should have voltage on it to provide the power supply for the outdoor LNB. Right now when I measure the coaxial cable connector, there is no voltage, what part may be bad ? remember to ...