Questions & Answers for: lighting pilot gas logs

...gas valve pilot open. A new thermopile will generate 750 millivolts. It cost less than $20 dollars but is difficult to replace. You should call a certified technician. They will charge you about ...

...gas logs. The pilot light I have a set of propane gas logs. The pilot light will not stay lit. It seems that the safety switch is not allowing the gas to flow through. Check the connection of the ...

...pilot lighting button down for a while (a full minute or longer, depending on the size and length of the supply line) before pure propane arrives at the pilot light jet. You should keep a lighted ...

...light area to tha gas valve. It feels the heat from the pilot and keeps the gas valve open for gas to flow to the pilot or to the logs when in the lit position. Without the gas valve will stay

...gas Pilot light stays lit various times, sometimes for several days then other times for a few minutes. Lights best when temp outside is below freezing. Pilot flame appears to receive too much air. ...

...a small voltage to open the gas valve. make sure the pilot flame is in contact with the thermocouple and hold the pilot start gas button on for at least 1 min befor turning it to the run ...

...from a bad pilot assembly: 1. The pilot won't stay on after lighting it 2. Pilot stays on but logs won't light. Depending on the unit, you may need a new thermopile or a whole new pilot

...lighting the pilot. HOW TO LIGHT THE PILOT: With the gas turned on with the key on the wall, find the black and white knob on the lower right of the gas log and turn it all the way to the right ...

...gas logs. Why don't they ignite? Pilot light IS lit The logs aren't supposed to ignite, they are made of ceramic, are supposed to look pretty and glow a bit. ...

...pilot lighting setting. I waited several times for 30 sec for the gas to get from line to pilot orifice. I checked the line before hooking up the logs & it has good supply. Line valves are in open ...