...the tub is not locked in place. What do I do? Thanks in advance. by removing the top cover of the lid there is no chance of water leaking from the tub ,check for any holes inside or outside the ...
lid switch and some part of it may be faulty. If you are handy you could test the switch for power and continuity by taking the top of the washer off (unplug the machine). If at all unsure call a Tech
...and off when driving how do i fix it could be the rear washer leaking inside the boot lid and causing the lock connection to get damp remove the boot lid cover just two screws and pull cover
...washer to wash but no spin with the lid open. Newer models won't allow for wash or spin. After you remove the case you will notice the lid switch quick connect has 3 wires. 2 hot wires and a green ...
...lid lock. After initial fill, all wash lights go out, advances to rinse, then beeps continuously. Have to shut machine off and start over. Continues to wash, but leaks out of top panel under lid. ...
...lid lock switch start cycle then stops even though lid lock on then starts beeping Check to see if there is water on the floor , I had similar problem I traced it to my tub leaking onto the shifter ...
Question about 2500 GPH Filter Pump Krystal Clear Model 633
...leaking from the filter lid. The O-ring is in place, but it seems like I cannot get the lid tight enough to stop leaking. Any ideas? It pump seems to be working properly but it sprays water from the ...
Question about 2500 GPH Filter Pump Krystal Clear Model 633
...lid lock light suppose the be on for the washer to work The washer does lock the door before it will do the washing. But the problem is probably not just the light burned out. Some system problem is ...
Question about 2500 GPH Filter Pump Krystal Clear Model 633
...lid lock switch on our maytag top load washer model number mvwc416fw. After replacing the lid lock the washer will fill and agitate for the wash cycle but it will not spin. The water just drains out ...
Question about 2500 GPH Filter Pump Krystal Clear Model 633
lid latch is in lock mode: Some Maytag Bravo top-load washers have a lock mode that prevents the lid from being opened during a wash cycle. Make sure that the latch is not in lock mode by checking the
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
