Questions & Answers for: liberty blower resistor

Liberty blower motor only works on hi speed. No low or middle speed. Is there a relay or thermal resistor for this and where is it located? Sounds like your blower motor resistor.

...Liberty 2003 fan blower will not work on the low settings...1 and 2. I am thinking its either the resistor on the blower motor, or the switch. Any help here would be greatly appreciated. sounds like ...

Blower only works on High 2006 Jeep Liberty: Was told that I may need to replace the switch and/or resistors. How do I replace the switch? I have found How To's on replacing the resistor. since blower

...Liberty - Air conditioner not blowing. Replaced blower relay switch - Still not blowing. When car is in motion, you can feel cold air at the vent, but the blower is not blowing the air into the car. ...

...liberty. the ac, heater fan only works on selector switch setting # 4. nay sugesstions on why fan does not work on settings 1, 2 or 3. The lower speeds are accomplished by running the power supply ...

...liberty , heater blower resistor i know was going bad , cause it only worked on setting 4 , but now its not working at all , its not blowing out period . so could it still be the heater blower ...

...blower resistor is bad. sounds like the blower mtr resistor located on the blower mtr housing or the switch on dash is not working blower resistor is the easiest test if your vehicle has one. remove ...

...blower motor on 2002 jeep liberty we have replaced the resistor and the fuses now what The motor should be behind the glove box under an insulation panel.Before you replace it you should check for ...

...Liberty. The blower fan wasn't working so I took a look. Found the power plug to the blower unplugged. Plugged it in and still blower didn't work. Checked + & - sides to plug and found no ground. The ...

...blower motor 2002 jeep liberty ground wire diagram for air condition blower motor 2002 jeep liberty... We Are Here To Help !! https://s28.postimg.org/izxo1llm5/blower_motor.jpg Click on the link. I ...